Anyone looking to get a Cam? Instead of the DCR, I was looking into the Yoshi ST-1M. Normally, the yoshi is $70 more than the DCR, so that is why i think most people go with the DCR. I have been talking with HR, and they are offering a GB on them. PM me or HR with the PRICE. But I need to find at least 4 other buyers! HR told me that the Yoshi cam is not a regrind. It is a billet cam cut to the correct specs! I dont completely it understand it, but this is what snakeibf said about the DCR...With the crower cam they took a stock Honda grom cam and ground the lobes for the new higher lift and duration required to make more power. This did give us more torque and power, but the drawback is they removed material and as a result the tappets must be turned way down thus changing the contact angle with the valve stem. This uneven contact causes excess wear on the tappet and valve stem because they are not butted flush up against each other. Additionally it also causes a lot of valve noise, especially when the engine is not warm. The best solution would be a cam billet cut to specs and not from an existing cam. This way you could retain the proper lobe size for a correct contact angle. The downside is higher production cost.
Posted on: Mon, 04 Aug 2014 01:12:02 +0000
Trending Topics
Recently Viewed Topics
© 2015