Basing stuff... Ive reconsidered my basing ideas... i had been - TopicsExpress



          

Basing stuff... Ive reconsidered my basing ideas... i had been using black anodized 1 fender washers, but it was creating a height difference between my slotta-base and cast-on base minis. I favor Mark Copplestone sculpts, particularly his work on grenadiers Future Wars line. The original line (now available from EM4 and Mirlington) used GW style round slotta bases and miniatures with a cast on tab. After the demise of grenadier, and the future Wars line, Mark set up his own company (Copplestone castings) and resculpted most of the line... with cast on bases. As I mix the two lines (and others) I had been gluing the Copplestone Castings mini straight to the washer, and clipping the tab of the Grenadier minis; gluing the soles of the feet to directly the washer. This created a height difference in the finished minis... accentuated by the tendency of the Copplestones to be a slight bit taller than the original line. I basically had three options: 1. Ignore the difference (ha!) 2. File down the cast on bases to make them paper thin, then glue them on the washer. This is a humongous pain in the ass. 3. Base them on thicker bases, and recess the cast on bases. I realized that between the washer thickness, and the cast on bases, the Copplestones were sitting pretty much as high as a slotta based Grenadier... so I decided to use those. For the Copplestones, Id carve out a void to fit the cast-on base, then back it with plasticard. I tried it on a couple minis and it seemed feasible... but i needed to order some 25mm slottas. Backing the Mantic Dead Zone project helped refine the plan; Before i could order slottas, i received my first backer shipment... chock full of these 1 plastic bases with a 10mm recess inthe middle. i realized that the Mantic recessed plastic bases were a perfect starting point for the Copplestones. Many of the female figures had a small enough base to just be glued in place. Some of the others, with the base carefully trimmed to the soles of the boots, would also fit an unaltered base.Wider stance figures were traced on the base, and then an X-Acto blade was used to enlarge the recess to accommodate the base. As the Mantic bases were not tapered like GW style slotta bases, I chose to use MDF rounds to base the tabbed minis. Thetab is trimmed to create two small pins, one on each foot, these are plotted on the base and then it is drilled with a bit of roughly the same width as the pins. Apply glue, press into base. I had a supply of gale Force Nines MDF bases, which I was a huge fan of, but as they seem to be discontinued, I ordered some rounds from a supplier in Australia, cheap, relatively near, and good bases. They are unfinished, which means i need to paint superglue over the surface before using watery basing materials like Vallejos pumice compound. But that isnt a big deal. In other news... while shopping at Joshin Electronics, I spotted a Gashapon (like those gumball machines with the cheap toys in the capsules) with soft plastic models from the 2014 Robocop film... three of Rococop himself, maybe 3 tall - too big for gaming. The forth possibility was ED209... in what looked to be something close to 28mm - he stands just under 70mm. I lucked out on the first try. Here he is pinned,and based, and the base has been coated in superglue to seal it. The other mini was an Alpha Forge DemoBot I picked up when MegaMinis folded; finally had the time, and a big enough base to put him together.
Posted on: Tue, 07 Oct 2014 08:24:23 +0000

Trending Topics



Recently Viewed Topics




© 2015