Brendon Mills write up of the 2wd Low Ranger mod!!! Ranger/BT50 Mod to get Low Range 2WD. Ok this is the Mod I have one to my Ranger so has to use Low range 2 wheel drive for backing a caravan etc. theres 2 relays under the bonnet on the left side of the brake booster. 1 plug is black=free solenoid and the other plug is Blue=Lock solenoid. I did the following mod. #1-Cut the red wire back about 100mm from the blue plug. #2- Run a length of 3mm twin core wire from driver side foot well into engine compartment. #3- place shrink wrap over the wires before soldeing each end of cut Red wire to one of each of the twin core wires, and then cover the soldered joins after soldering with the shrink wrap. #4-Using a Narva rocker switch #63020BL with amber LED, run an earth wire to ground the switch and run the twin core wires to the switch Power & Acc poles. #5- To Test. Start the Ute. The Led on Rocker switch will light up if it is in the On position. Move the 4WD lever to 4WD, the Rocker switch Led will turn OFF. Move forward to engage RFW (Remote Free Wheel hubs) and the RFW light on the dash will light up. This will give you 4 wheel drive. Now move the 4WD lever back to 2WD and disengage the RFW switch so the dash light goes out. To Select 2WD Low Range. Turn the Rocker switch OFF (LED OFF). Move 4WD lever to Low Range and move the ute forwards, the RFW light will not come ON. This will give you 2 Wheel Drive Low Range. When you reselect 2WD High Range, turn the rocker switch back on. This will sometimes bring the RFW light on so just push the RFW button again to turn it OFF. Cheers Millsy
Posted on: Sat, 23 Aug 2014 12:38:43 +0000
Trending Topics
Recently Viewed Topics
© 2015