CLCBulbs 813-932-1547 (continued)... Before you cut any - TopicsExpress



          

CLCBulbs 813-932-1547 (continued)... Before you cut any wires, it is recommended that you check both the hot and neutral feed wires for voltage with respect to ground. (And see the alternative to cutting in step 11 before doing any cutting.) The voltage can be checked with a simple voltmeter or voltage sensor. Locate the ballast and follow the wires until you find the wire nuts (caps) that connect wires of the same color (red to red, etc.). If there are no wire nuts, you will have to cut the wires about 12 inches (300 mm) from the center of the fixture on each side. Complete this until all wires are cut or all wire nuts are removed. Unscrew the nut holding the ballast to the fixture while holding it in place with your other hand. This is best done with a nut driver or socket wrench. Remove the ballast by lowering the side held by the nut, and sliding it in that direction. (to be continued)... Commercial Lighting Tampa 8139321547
Posted on: Tue, 23 Jul 2013 19:58:03 +0000

Trending Topics



Recently Viewed Topics




© 2015