I have a 92 ford tempo demo car complete. it has soild roll bar behind the drivers seat bolted to the underside of the car and to the roof. has 2X4 bracing bolted to the inside of the drivers and passenger door has a drive shaft in the drivers door and another 2X4 bracing in the passenger door all chained in. the trunk is chained shut and have 2X4 bracing under the plastic bumper cover bolted and welded in. the front bumper is off of a 90 E150 van cut and welded solid on both... sides and bolted and welded to the front of the car so it wont break loose. donut tires in the back and full size in the front have 4 full size. I pulled the cv axle cut the boot off of it and pulled it apart welded the spindles on the inside but left it so it still rolls then took a washer and grinded it down to fit inside of the cv case and cut it in half so welded on side in with the cv in already and then did the same to the other side so it can not dislocate like they have been known to do. I built this car last yr and never got to run it the clutch went out so it sat at my farm in the rain and snow went over and throw a fresh batt in her she started right up runs like a champ does need the clutch replaced it drives till it gets hot then is done till it cools again everything goes besides batt and gas tank and please dont offer me like 200 bucks like everyone else ill scrap it before I sell it for that even tho the clutch is out its still built and I dont have time to replace it demo is over already askin 600 obo will trade for a working plasma cutter location Calhoun il six one eight 946 6342 thanks for looking dylan
Posted on: Mon, 15 Sep 2014 00:58:02 +0000
Trending Topics
Recently Viewed Topics
© 2015