If anyone is interested in this set let me know. I just freshly restored them. * Baked off the glass lens * Removed all old OEM glue (20 years old) * Cleaned out the headlight bucket * Removed the color insert * Remove the glass projectors and clean them to remove finger prints and dust * Lay 2-3 coats of flat black paint (helps absorb light from halos) * Sand blasted and painted all mounting hardware as shown * Lay 2-3 coats of flat black paint to hardware * Seal the mounting hardware so the paint is less likely to chip of fade * Wire brush the tops of the screws for mounting hardware and give light coat of black paint * Install halos (very bright SMD LED with shroud as shown) * Mount halos on the rings with high quality clear epoxy * Shrink heat wrap wires for halos in black so they are not noticeable. * Remove the old L rubber parts from rear of bucket and replace with new rubber. * Run Halo wires through bucket * Solder 2 foot extension for positive and negative for each halo. * Shrink heat connects * Place new OEM quality glass seal. * Thoroughly clean the inside and exterior glass * Place glass back on headlight bucket and seal.
Posted on: Sat, 26 Jul 2014 17:01:41 +0000
Trending Topics
Recently Viewed Topics
© 2015