Im going to make the rounds on this one, Ive been away from triples for a few years and need a little help...I have a roller bearing clutch actuator from a 75 H2 that I am putting on my 72 H2 to make the clutch pull more bearable...the body itself is a good bit longer than the 72 H2 unit as visible in the third photo...and the 72 engine in my bike has a different internal seal that will be damaged if this isnt spaced out properly (actuator will ram into it as I understand). Redline Motorsports used to sell the spacer but their site is not working...and Im afraid Ive waited too late to buy from them...what would be your suggestion as to make this work?
Posted on: Mon, 18 Aug 2014 07:01:49 +0000
Trending Topics
Recently Viewed Topics
© 2015