Looking to clean up some more wiring in a few of my Minis and im - TopicsExpress



          

Looking to clean up some more wiring in a few of my Minis and im using a UBEC and the ESCs i have have 3 wires and only needing the Signal wire was wondering what if I removed the other two wires would be ok. On running them off of a CC3d and a Naze32 board or should I leave them on for later programing or tuning? I know dont use the RED wire but then there is no power from it but to remove it from plug but how about remove all but the one signal wire and slid the other 2 motor signal wires in one plug for a cleaner install?
Posted on: Thu, 04 Dec 2014 16:48:53 +0000

Trending Topics



Recently Viewed Topics




© 2015