PiTap: Automated packet capture on a Raspberry Pi #piday #raspberrypi adafru.it/b113777 The PiTap is a device I put together with the intention of being a pentesting tool, but it has also found utility in facilitating data collection as part of my Industrial Control System (ICS) security research. I need to do a lot of packet captures; often at multiple points within a network. This can be quite a time consuming process to set up and configure, so I set out to put together what I like to call a “plug-and-capture” device. Design Requirements -Small and portable. -The bridge and packet capture would start automatically on boot. -It didn’t need to run on mains power. -Minimal hardware configuration allowing the SD card to be cloned and run on multiple stock devices. Hardware -Raspberry Pi. -USB power supply. I used the battery from my Wifi Pineapple MK4 battery; however, I have had success in running it from a cheaper Duracell USB battery (5V 0.6A). -USB Ethernet adapter (the Pi only has one Ethernet port).
Posted on: Fri, 16 May 2014 21:26:45 +0000
Trending Topics
Recently Viewed Topics
© 2015