Who else loves it when the same shit is posted every other day? I - TopicsExpress



          

Who else loves it when the same shit is posted every other day? I have answered some of the more common questions asked. Yes its a long post so grab a stubbie or 8 and have a read. How to replace bench 3/4 seat with gxl/rv seat. If you dont have a bucket seat yet and want to find the 4th bolt hole. ( or use your new seat if u have it) unbolt your drivers seat and bolt it in the passenger side using the three available holes. Drill the centre of the 4th hole smaller and work your way up until you find the thread. Be carful not damage the thread. Done you now have 4 threaded holes to bolt you new bucket seats up. This will need engineering/certifying/mod plating or what ever the hell your state uses. No you cant go from underneath. Fuel tank and body brace is in the way. What other seats bolt into my 75/79? NONE! Unless they are 75/79 seats! Do the work and make them fit. Some simple flat bar bolted in the factory holes then fit your new seats in place and either and tap holes or weld some nuts under neither. Use your brain and a bit of common sense its not that hard. If it is....dont try and fit different seats to your car. What causes steering wobbles in the 70 series? First. Get wheel balance and wheel alignment checked!!! If that doesnt fix it put the car On flat ground get some one to rock the steering back and forth and get off facebook and under the car and look at all your steering joints. Very minor movement in your panhard rod bushes will cause massive steering wheel shake. Drag link ends. Check them! Any movment will cause steering shake. Check wheel bearings and swivel hub bearings too. Use Abit of mechanical aptitude. If u dont have this, pay some one who does. Yes your three inch exhaust sounds good. As good as all the others posted on here. Cross over pipes are worth it and g turbos are sick! Yes chip them. It does make them go hard! Block your Egr and run a catch can. Your engine will love you long time. And yes you do need a 10mm hole in the blanking plate. Are extractors worth it on a 1hz. May give you a bit more power and a better sound but for the $1000 your gonna spend on a full exhaust you may aswell save some more and turbo it. 1hzs arent designed for turbos and they dont really love it. But there are millions of turbo 1hzs getting around so it cant be that bad. Yes your engine will take it but dont blame me if goes bang. Your 88 rusted out hj75 is probably worth half of what you think it is. And no. No one has a steel windscreen surround with no rust for a 75. There none left in the world. They all rust! Yes a 6cyl 79 series bullbar will fit on your 75. No a v8 one wont bolt on. Everyone loves a good canopy! Show us what you got! Firbre glass replacement panels (FPR) sell the 6cyl bonnet with the v8 scoop. Yes they cost a shit load, dont like it? Make your own. Good luck. Spring over makes a 75 huge. Still no flex and for the effort may aswell coil convert it. Finally for the record 1HD FTE cruisers are shit loads better than the V8s
Posted on: Tue, 20 Jan 2015 11:23:24 +0000

Trending Topics



Recently Viewed Topics




© 2015