plastic recycling equipment to use and works Use plastic recycling equipment to be sequentially turn on the power, set the temperature and note heating is normal, for how to effectively control the temperature of the host plastic recycling equipment, we posted the relevant content, you can see. Cleanup hopper unit, access to water, check the gear oil, engine oil, heat butter and oil level lubrication, the new machine at the latest six months to replace the gear oil, moving parts at least once a week to add oil. When the temperature is approaching the set temperature, the preparation of materials and in turn starts the main motor. plastic recycling equipment temperature must reach the set temperature, open the feeding device to feed into the washing or cleaning material residues within the screw until the new material squeezed out, then squeeze the material pause, fast place to install the filter plate and die . Before closing the die, die after closing open plastic recycling equipment main screw motor operator at this time away from the die, die hard material to prevent clogging burst wounding until die extrusion silk material, and then close the pelletizing cover and connect the cut material holder and lock. Turn over the operation in place in order to open all the fan>; shaker>; pelletizer>; the operation of the host. When the grain of normal regulatory pelletizer, frequency control to adjust the particle size. Before discharge screw must let pelletizer kept turning, if it is water-cooled spray pelletizing, diced cover first through the water, and finally open the host official production. Start out slow and fast host by adjusting the frequency control host and granulator particle size according to demand, and only reached the two coordination in order to make a better cut out uniform particles and maximize the amount of particles. Stop work order of operations and start production operations in reverse order, first off the host drive, and then click Close auxiliary power, the last fast cleanup die, the die is cooled to prevent clogging (Special Note: Stop after every shift jobs die discharge filter plates must be completely clear hole to install the production again, or else die because there is danger of explosion blockage). In production, after the raw material into the auger-type grinder and clean exhaust cleaning the pool, and then the next fork action to move forward and re-cleaning debris from entering the feeder to feed the fish from the pool hopper, fell smoothly from the hopper screw is twisted to screw with the rotation of the screw was a screw forced to move forward, while being heated in the furnace compression and plastic itself, stirring movement under the effect of heat external and internal forces, rapidly increasing the temperature of the plastic material is melted to liquid form so that it is uniformly extruded from the cylinder, and then extruded into the negative stirring machine, due to the action of the filter, the manifold and head, etc. so that the resistance material is formed in the process strong pressure, it is very dense material pressure for plastic heavy uniform discharge from the vent strip, and then fall into the pool to cool, and finally into the pelletizer section granules. pr-plasticrecyclingmachine/news/html/?425.html
Posted on: Fri, 16 Jan 2015 05:54:19 +0000
Trending Topics
Recently Viewed Topics
© 2015