Looks like I got a job ahead of me tomorrow. Right after I did the dishes in the concession trailer the Shurflo water pump finally gave up the ghost. I got about 60 or so rivets to remove from the skin covering the sink base. Then I need to make sure that the fresh water tank is emptied out. Then I unplug the pump, remove it, cut PVC pipes the geniuses hard glued in, figure out what PEX fittings are needed, install replacement that will have to run off a 6 amp battery charger, re-plumb, kneel down and say a prayer, and hope that all goes well. Note to self: Do NOT rivet the skin back on, use hex head self-tapping sheet metal screws like should have been done in the first place. Also while skin is off the sink enclosure relocate replacement hot water heater under sink after removing kaput one :) Just chalk it up to the cost of doing business !
Posted on: Sun, 18 Aug 2013 00:48:37 +0000